PX4006 Modern Rectifiers and Resonant Converters Syllabus:
PX4006 Modern Rectifiers and Resonant Converters Syllabus – Anna University PG Syllabus Regulation 2021
OBJECTIVES:
To inculcate knowledge on harmonics standards.
To impart knowledge on the design power factor correction rectifiers for UPS applications.
To familiarize the design resonant converters for SMPS applications.
To provide knowledge on dynamic analysis of DC to DC Converters.
To introduce the control techniques for control of resonant converters.
UNIT I POWER SYSTEM HARMONICS & LINE COMMUTATED RECTIFIERS
Average power-RMS value of an AC waveform-Power factor-AC line current harmonic standards IEC 1000-IEEE 519- The Single phase full wave rectifier-Continuous Conduction Mode Discontinuous Conduction Mode-Single phase Rectifier’s behavior for large value of Capacitance – Minimizing THD for small value of Capacitance- Three phase rectifiers- Continuous Conduction Mode-Discontinuous Conduction Mode- Introduction to Harmonic trap filters.
UNIT II PULSE WIDTH MODULATED RECTIFIERS
Properties of Ideal rectifiers-Realization of non-ideal rectifier-Single phase converter system incorporating ideal rectifiers-Modeling losses and efficiency in CCM – high quality rectifiers-Boost rectifier-expression for controller duty cycle-expression for DC load current-solution for converter Efficiency.
UNIT III RESONANT CONVERTERS
Review on Parallel and Series Resonant Switches-Soft Switching- Zero Current Switching – Zero Voltage Switching –Classification of Quasi resonant switches-Zero Current and Zero Voltage Switching of Quasi Resonant Buck converter- Zero Current and Zero Voltage Switching of Quasi Resonant Boost converter: Steady State analysis.
UNIT IV DYNAMIC ANALYSIS OF SWITCHING CONVERTERS
Review of linear system analysis-State Space Averaging-Basic State Space Average Model- State Space Averaged model for Buck Converter, Boost Converter, Buck Boost Converter and Cuk Converter.
UNIT V CONTROL OF PWM RECTIFIRS
Pulse Width Modulation-Voltage Mode PWM Scheme-Current Mode PWM Scheme- Average current control-Current programmed Control- Hysteresis control- Nonlinear carrier control –Design of Controllers: PI Controller, Variable Structure Controller for source current shaping of PWM rectifiers.
TOTAL : 45 PERIODS
OUTCOMES:
CO1: To understand the standards for supply current harmonics and its significance.
CO2: To design power factor correction rectifiers for UPS applications.
CO3: To 35nalyse and design the resonant converters.
CO4: To derive the state space model of basic and derived DC-DC converters.
CO5: To design an appropriate controller for PWM rectifiers.
REFERENCES:
1. John G. Kassakian, Martin F. Schlecht, George C. Verghese, “Principles of Power Electronics”, Pearson, India, New Delhi, 2010
2. Philip T Krein, “ Elements of Power Electronics”, Oxford University Press,1998
3.Ned Mohan, “Power Electronics: A first course”, John Wiley,2011
4.IssaBatarseh, Ahmad Harb, “Power Electronics- Circuit Analysis and Design, Second edition,2018