AP4111 Electronics System Design Laboratory Syllabus:

AP4111 Electronics System Design Laboratory Syllabus – Anna University PG Syllabus Regulation 2021

COURSE OBJECTIVES:

 Design of instrumentation amplifier and voltage regulator
 Design of PCB layout
 Write a Verilog HDL coding of various combinational circuits
 Verify the design functionality for various memory modules
 Design of PLL circuits

LIST OF EXPERIMENTS:

1. Design of a 4-20 mA transmitter for a bridge type transducer. Design the Instrumentation amplifier with the bridge type transducer (Thermistor or any resistance variation transducers) and convert the amplified voltage from the instrumentation amplifier to 4 – 20 mA current using op-amp. Plot the variation of the temperature Vs output current.
2. Design of AC/DC voltage regulator using SCR Design a phase controlled voltage regulator using full wave rectifier and SCR, vary the conduction angle and plot the output voltage.
3. PCB layout design using CAD Drawing the schematic of simple electronic circuit and design of PCB layout using CAD
4. HDL based design entry and simulation of Parameterizable cores of Counters, Shift registers, State machines, 8-bit Parallel adders and 8 –Bit multipliers.
5. HDL based design entry and simulation of Parameterizable cores on the simple Distributed Arithmetic system. Test vector generation and timing analysis.
6. HDL based design entry and simulation of Parameterizable cores on memory design and 4 – bit ALU. Synthesis, P&R and post P&R simulation, Critical paths and static timing analysis results to be identified. FPGA real time programming and I/O interfacing.
7. Interfacing with Memory modules in FPGA Boards. Verifying design functionality by probing internal signals.
8. Realization of Discrete Fourier transform/Fast Fourier Transform algorithm in HDL and observing the spectrum in simulation.
9. Invoke PLL module and demonstrate the use of the PLL for clock generation in FPGAs. Verify design functionality implemented in FPGA by capturing the signal in Oscilloscope

TOTAL :45 PERIODS

COURSE OUTCOMES:

CO1: Design an instrumentation amplifier and voltage regulator
CO2: Design a PCB layout using CAD tool
CO3: Write a Verilog code for various combinational and sequential circuits
CO4: Develop a memory module with FPGA
CO5: Design an PLL circuit

REFERENCES:

1. Neil H.E. Weste, David Harris, Ayan Banerjee, “CMOS VLSI Design- A circuits and Systems Perspective”, Third Edition, 2013, Pearson education.
2. M. Morris Mano, Michael D. Ciletti, “Digital Design with an introduction to Verilog HDL”, PHI, 6th Edition, 2018
3. James E. Palmer, David E. Perlman,“Schuams Outlines-Introduction to Digital Systems”, Tata McGraw Hill, 2nd Edition 2003
4. Sergio Franco, “Design with operational amplifiers and analog integrated circuits”, 3rd Edition, Tata McGraw Hill, 2007
5. D.Roy Choudhry, Shail Jain, “Linear Integrated Circuits”, New Age International Private Limited, 4th Edition, 2010